E-flite P-47D Thunderbolt 400 ARF - Manual (Page 25)

Note: A small bend may be required in the
rudder pushrod after it exits the fuselage
to prevent the pushrod from binding when
attached to the control horn.
 6. Use the included hook and loop material to
attach the receiver in the fuselage. Route the
antenna wire out of the fuselage and to the tail of
your P-47D Thunderbolt.
Note: Do not cut the antenna wire as it will
greatly reduce the range of your radio system.
Be sure to route the antenna wire as far away
from all electronic components and pushrods as
possible. We suggest routing the antenna out
the rear of the hatch or cooling air exits and
attaching it to the top of the vertical fin.
25