E-flite P-47D Thunderbolt 400 ARF - Manual (Page 10)

Wing Preparation
Required Parts
• Wing • Servo (2)
• Y-Harness • Aileron pushrod (2)
• Landing gear screws (4)
• 18mm x 20mm two-sided tape (2)
Required Tools and Adhesives
• Drill • Drill bit: .050"
• Hobby knife
• Low-temperature hot glue
• Phillips screwdriver (small)
 1. Use the radio system to electronically center the
aileron servos. Attach a control horn to each of
the servos.
 2. Apply the 18mm x 20mm two-sided tape to
the servos. Test fit the servos into the wing. The
servo arm faces to the leading edge. After fitting,
remove the backing from the tape to secure the
servos into the wing.
10