E-flite F-15 Eagle DF ARF - Manual (Page 28)

28 E-flite F-15 Eagle ARF Assembly Manual
Wing Panel Installation
Required Parts
Assembled wing panel (right and left)
Assembled fuselage
Required Tools and Adhesives
6-minute epoxy Painter's tape
 1. Test fit the wing panel to the fuselage. You will need to
cut a hole to route the aileron servo lead into the fuselage
as shown.
 2. Position the wing so it is parallel to your work surface
when viewed from the front of the aircraft. Makle sure
the fuselage is parallel to the work surface as well. Use
6-minute epoxy to glue one wing panel to the fuselage.
Use painter's tape to keep the wing tight against the
fuselage while the epoxy cures.
 3. Repeat Steps 1 and 2 to attach the remaining wing
panel to the fuselage. Make sure the alignment of the
second wing panel matches that of the first panel so the
aircraft has an equal amount of dihedral for both right
and left panels. If the dihedral does not match, it may
require a lot of trim to correct and will not provide the
best flight performance.