E-flite F-15 Eagle DF ARF - Manual (Page 15)

15 E-flite F-15 Eagle ARF Assembly Manual
 15. Secure the fan cover in position using two 2mm x
22mm sheet metal screws and a #1 Phillips screwdriver.
Note: You might have to remove a small amount of foam
from the inside area of the Power Hatch to allow the
hatch to fit down nice and tight. This is due to the wires
from the stab servos running through this area.
Fixed Gear Installation
Required Parts
Main gear (right and left) Nose gear
Wheel (3) Spring washer (3)
Servo w/hardware 2mm x 8mm sheet metal screw (12)
Pushrod connector Nylon nut
185mm pushrod wire w/clevis
Required Tools and Adhesives
Hex wrench: 1.5mm Phillips screwdriver: #1
Threadlock Hobby knife
Side cutters
 1. Secure the main gear in the fuselage using
four 2mm x 8mm sheet metal screws and a #1
Phillips screwdriver. The gear face toward the
front of the fuselage.