E-flite F-15 Eagle DF ARF - Manual (Page 27)

27 E-flite F-15 Eagle ARF Assembly Manual
 4. Slide a 75mm pushrod wire into the hole in the
connector. Use a hobby knife to cut a 2mm wide
slot in the aileron near the hinge line using the wire
as a guide. Keep the wire perpendicular to the servo
while cutting the slot.
 5. Use 6-minute epoxy to glue the control horn in the
aileron as shown.
 6. Connect the clevis to the control horn. With the
aileron and aileron servo centered, tighten the setscrew
in to connector with a 1.5mm hex wrench to secure the
pushrod wire.
 7. Use the supplied tape to cover the aileron servo and
wire as shown. You may now cover the carbon spar with
the white and orange tape.
 8. Repeat Steps 1 through 7 to install the remaining
aileron servo and linkage.