E-flite F-15 Eagle DF ARF - Manual (Page 12)

12 E-flite F-15 Eagle ARF Assembly Manual
 4. Secure the impeller to the motor shaft using a 1.5mm
hex wrench and setscrew. Be sure to use threadlock when
installing the setscrew.
 5. Solder the appropriate connector to the motor leads to
connect the motor to your particular speed control. Also
install the appropriate connector to the speed control to
connect the motor battery.
 6. You can check the operation of the motor at this time.
Be very careful that you do not encounter the impeller
when checking the operation of the fan. If any rubbing
occurs, you can remove the fan rotor assembly and
work the area with a rotary tool and a fine drum sander
until all the black area is removed. Remove very little,
maintaining the circumference of the shroud. Reinstall the
impeller and run again. There should be no rubbing at
all during operation.
 7. Slide the speed control into the opening between the
fan tunnels and into the main fuselage.