E-flite Enticement F3P ARF - Manual (Page 30)

30 E-flite Enticement F3P Profile Assembly Manual
 5. Position a 2-inch (50mm) carbon rod between the
bottom of the aileron and each of the drag brakes. Use
foam-safe CA to glue the carbon rods to the aileron.
Double-check the alignment to make sure the drag brakes
are square to the aileron, then use foam-safe CA to glue
the carbon rods to the drag brakes.
 6. At this time it is suggested to go back and check all
the glue joints to make sure they are solid. Apply foam-
safe CA to any areas that may need a little extra glue.
 7. Use foam-safe CA to glue the foam wheel pant onto
the molded skid. Use the notch in the wheel pant to
center it on the skid.