E-flite Enticement F3P ARF - Manual (Page 11)

11 E-flite Enticememt F3P Profile Assembly Manual
 7. Locate the bottom fuselage stiffeners Note the
positioning of the stiffener in the following photo.
Glue the stiffener to the top edge of the foam firewall
to start. Glue the stiffener to the fuselage pieces using
foam-safe CA.
Carbon Rod/Landing Gear Installation
Required Parts
Assembled airframe Molded skid (2)
1 5 /
8
-inch (41mm) carbon rod (2)
5 5 / 8
-inch (144mm) carbon rod (2)
10 3 /
4
-inch (274mm) carbon rod (2)
11 1 /
2
-inch (294mm) carbon rod (2)
3/32 x 6 7 / 8
-inch (2.5mm x 175mm) landing gear strut (2)
Required Tools and Adhesives
Foam-safe CA Foam-safe CA activator
Hobby knife Square
Note: You must take extra care in this section to
maintain the alignment of your airframe and to not
build in any unwanted twists in the airframe. Make
sure to keep everything aligned and the wing straight
with the fuselage. Also make sure not to induce any
twist in the wing, which could adversely affect the flight
characteristics of your aircraft.
 1. Use a hobby knife to remove the hinge tape covering
the slots for the carbon rods along the aileron hinge line
on both the left and right wing panels.