E-flite Enticement F3P ARF - Manual (Page 29)

29 E-flite Enticememt F3P Profile Assembly Manual
 2. Position a 3 1 /
8
-inch (80mm) carbon rod between
the wing and each of the side force generators. Use
foam-safe CA to glue the carbon rods to the wing.
Double-check the alignment to make sure the side force
generators are square to the wing; then use foam-safe
CA to glue the carbon rods to the generators.
 3. Measure and mark the center (top to bottom) of the
drag brake.
 4. Use foam-safe CA to glue the drag brakes to the
trailing edge of the aileron using the notches in the
aileron as guides. Also make sure the drag brake is
square to the aileron as shown.