E-flite Enticement F3P ARF User Manual

Page 21

E-flite Enticememt F3P Profile Assembly Manual



8. With the ailerons and aileron servo centered,

check the distance between the horns and pushrods.

There should be a 1/16-inch (1mm) gap between them.

If not, use side cutters to trim the pushrods to the correct

length.



9. Slide the heat shrink tubing on the control horns,

then slide the pushrods into the heat shrink, centering

the heat shrink between the two. Use a soldering iron to

shrink the tubing onto the control horns and pushrods for

both ailerons.

Note: You must use a soldering iron to shrink the tubing.

The heat from other methods cannot be controlled as well

and will cause damage to your airframe.



10. Repeat Steps 7 though 9 for the opposite aileron

pushrod installation.