E-flite Enticement F3P ARF - Manual (Page 13)

13 E-flite Enticememt F3P Profile Assembly Manual
 7. Locate the two 5 5 /
8
-inch (144mm) carbon rods.
Insert the carbon rods between the vertical fin and
horizontal stabilizer. Glue the rods at the fin ONLY
using foam-safe CA, then use a square to check to
make sure the fin is square to the stabilizer. Once the
fin and stabilizer are square, use foam-safe CA to glue
the carbon rods to the stabilizer.
 8. Locate the two 3/32 x 6 7 /
8
-inch (2.5mm x 175mm)
landing gear struts. Use foam-safe CA to glue the molded
skids to the struts.