E-flite Enticement F3P ARF - Manual (Page 10)

10 E-flite Enticement F3P Profile Assembly Manual
 5. Use a square and foam-safe CA to glue the vertical
and horizontal fuselage pieces together. Start at the
front and slowly work your way toward the rear of the
fuselage, gluing small sections at a time.
Note: Use low-tack tape to tape the control surfaces in
their neutral positions. This will make the airframe easier
to handle during assembly. Be careful not to tape the
printed surfaces as there is a chance of the printing
coming off when removing the tape.
 6. Locate the top fuselage stiffeners Note the positioning
of the stiffener in the following photos. Glue the stiffener
to the top edge of the foam firewall to start. Again,
work slowly, gluing the stiffener to the fuselage pieces.
The stiffener is positioned at a 45-degree angle to each:
position it equally on both fuselage pieces.