E-flite T-34 Mentor 25e ARF - Manual (Page 20)

20 E-flite T-34 Mentor 25e ARF Assembly Manual
 5. Use two 3mm x 12mm self-tapping screws and
a nylon strap to secure the panels together. Holes
have been pre-drilled for the screws. Make sure to
place 2–3 drops of thin CA into the holes before
starting the screws. Use a #1 Phillips screwdriver to
tighten the screws.
 6. Connect the remaining side of the flap linkage
to the flap control horn. Make sure both flaps are
aligned with the trailing edge of the wing when the
flap servo is in the UP position.
Make sure both flaps are UP if you are
flying your model with fixed flaps.
Main Landing Gear Installation
Required Parts
Wing assembly Nylon strap (4)
Main landing gear (2)
3mm x 12mm self-tapping screw (8)
Required Tools and Adhesives
Phillips screwdriver: #1
 1. Insert the main landing gear in the wing panel.
It will fit flush to the bottom of the wing when
installed.
 2. Use two nylon straps and four 3mm x 12mm
self-tapping screws to secure the landing gear to
the wing. Use a #1 Phillips screwdriver to tighten
the screws in the pre-drilled holes in the bottom of
the wing.
 3. Repeat Steps 1 and 2 to attach the remaining
gear to the opposite wing panel.