E-flite Sukhoi SU-26m 480 ARF - Manual (Page 6)

6 E-flite Sukhoi SU-26m 480 ARF Assembly Manual
 2. Attach the Outrunner motor to the front of the
firewall using two plywood X-mount spacers, four
#4 washers and four 4-40 x 5/8-inch socket head
screws. Tighten the screws using a 3/32-inch ball
driver or hex wrench.
IMPORTANT INFORMATION ABOUT
YOUR BRUShLESS ESC
Make sure your ESC brake is programmed to Off.
Also, be sure to use an ESC with the proper 9V cutoff
when using 3-cell Li-Po packs, or 6V cutoff when using
2-cell Li-Po packs.
 3. Solder any connectors to the speed control to
connect to the motor battery and motor if necessary.
Use hook and loop tape to secure the speed control
inside the fuselage as shown. Make sure to guide
the leads for the motor through the fuselage.
 4. Connect the leads from the ESC to the leads
from the motor. Use a tie wrap (not included) to
secure the motor leads so they will not interfere
with the operation of the motor.
 5. Connect the speed control to the radio system and
motor battery. Check that the motor is rotating in
the correct direction. It will rotate counterclockwise
when viewed from the front of the aircraft. Use the
instructions with your speed control to correct a
motor that is operating in the wrong direction.