E-flite Sukhoi SU-26m 480 ARF - Manual (Page 3)

3 E-flite Sukhoi SU-26m 480 ARF Assembly Manual
Recommended Radio Equipment
You will need a minimum of a 6-channel transmitter,
receiver and four servos. You can choose to purchase
a complete radio system. If you are using an
existing transmitter, just purchase the other required
equipment separately. We recommend the crystal-
free, interference-free Spektrum ™ DX6i 2.4GHz DSM ®
6-channel system. If using your own transmitter, we
recommend the E-flite S75 Sub-Micro servos.
If you own a Spektrum radio, just add a DSM2 ™
receiver and four E-flite S75 Sub-Micro servos. We
show the installation of the AR6200 receiver in the
manual.
Radio System
SPM6600 DX6i DSM2 6CH system
Or Purchase Separately
SPMAR6200 AR6200 DSM2 6-Channel Full
Range Receiver (for DX5e, DX6i,
or DX7)
And
EFLREX6L 6-inch Extension,
Lightweight (2)
EFLREX12L 12-inch Extension,
Lightweight (2)
Optional Accessories
EFLA110 Power Meter
EFLC3005 Celectra ™ 1- to 3-Cell
Li-Po Charger
EFLC505 Intelligent 1- to 5-Cell
Balancing Charger
EFL2856 Dummy Motor
EFLA152 1/9-scale Aerobatic Pilot
EFL2863 Wheel Pants
EFLSP175 1 3 /
4
-inch (45mm) Aluminum
Spinner w/4mm & 5mm Collets
Brushless Outrunner Setup
EFLM1505 Park 480 Brushless Outrunner
Motor, 1020Kv
APC12060E 12x6 Electric Propeller
EFLA1040L 40-Amp Lite Pro Switch-Mode
BEC Brushless
THP21003SPL2 2100mAh 3S 11.1V 20C Li-Po,
13AWG
Required Tools and Adhesives
Tools & Equipment
Felt-tipped pen Hobby knife (#11 blade)
Mixing sticks Nut driver: 5mm
Paper towels Pin drill
Ruler (EFLA264) Square
String/dental floss T-pins
Low tack tape Side cutters
Sand paper Petroleum jelly
Waxed paper Rubbing alcohol
Epoxy brush
Phillips screwdriver: #0, #1, #2 (EFLA257 and
EFLA258)
Hex wrench or ball driver: 3/32-inch (EFLA251)
Drill bit: 1/16-inch (1.5mm)
Adhesives
Threadlock Canopy glue
Thin CA Medium CA
Tie wrap
6-Minute Epoxy (HAN8000)
30-minute epoxy (HAN8002)
Note on Lithium Polymer Batteries
Lithium Polymer batteries are significantly
more volatile than alkaline or Ni-Cd/
Ni-MH batteries used in RC applications.
All manufacturer’s instructions and warnings
must be followed closely. Mishandling of
Li-Po batteries can result in fire. Always
follow the manufacturer’s instructions when
disposing of Lithium Polymer batteries.
Warning
An RC aircraft is not a toy! If misused, it can cause
serious bodily harm and damage to property. Fly
only in open areas, preferably at AMA (Academy of
Model Aeronautics) approved flying sites, following all
instructions included with your radio.
Keep loose items that can get entangled in the
propeller away from the prop, including loose clothing,
or other objects such as pencils and screwdrivers.
Especially keep your hands away from the propeller.
During the course of building your Sukhoi SU-26m,
we suggest that you use a soft base for the building
surface. Such things as a foam stand, large piece of
bedding foam or a thick bath towel will work well and
help protect the model from damage during assembly.
The Spektrum trademark is used with permission
of Bachmann Industries, Inc.