E-flite Sukhoi SU-26m 480 ARF - Manual (Page 19)

19 E-flite Sukhoi SU-26m 480 ARF Assembly Manual
 2. Use a pin drill and 1/16-inch (1.5mm) drill bit
to drill holes through the servo mounting tabs and
into the fuselage.
 3. Apply 2–3 drops of thin CA into each of the two
holes to harden the surrounding wood.
 4. Use a #0 Phillips screwdriver and the screws
provided with the servo to secure the elevator servo
in the fuselage.
 5. Use side cutters to remove one of the arms from
a 3D servo horn. Use a pin drill and 1/16-inch
(1.5mm) drill bit to enlarge the outer hole of the
servo horn.
 6. Attach the micro control connector to the servo
horn. Be sure to use the included retainer to secure
the micro control connector.
 7. Center the elevator servo. Use a #0 Phillips
screwdriver to remove the stock servo horn and
install the horn prepared in the previous steps.