E-flite Sukhoi SU-26m 480 ARF - Manual (Page 10)

10 E-flite Sukhoi SU-26m 480 ARF Assembly Manual
 2. Place the servo in the wing. Guide the servo
lead out through the opening at the wing root.
 3. Use a pin drill and 1/16-inch (1.5mm) drill bit
to drill two holes through the servo mounting tabs
into the wing. Use care not to drill through the top
of the wing by accident.
 4. Apply 2–3 drops of thin CA into each hole to
harden the surrounding wood. This will make the
screws more secure and less likely to vibrate loose.
 5. Use a #1 Phillips to secure the aileron servo
using the screws provided with the servo.
 6. Use 6-minute epoxy to attach the control horn to
the aileron.
 7. Use a #0 Phillips screwdriver to remove the stock
servo horn from the aileron servo.