Banner SureCross DX80 Wireless M-GAGE Node - Manual (Page 13)

P/N 131598 rev. F
13
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164
SureCross™ DX80 M-GAGE™ Node with Integrated Battery
Included with Device Model Qty Item
Mounting Hardware Kit BWA-HW-001 4 Screw, M5-0.8 x 25mm, SS
4 Screw, M5-0.8 x 16mm, SS
4 Hex nut, M5-0.8mm, SS
4 Bolt, #8-32 x 3/4”, SS
SureCross Literature CD 79685 1 SureCross Literature CD
Data sheet 1
Installation Pack BWA-HW-005 M-GAGE Installation Pack (Two 1 1/4 thick foam pieces, PTFE tape)
It is Banner Engineering’s intent to fully comply with all national and regional regulations regarding radio frequency emissions. Customers who want to re-export this product to a
country other than that to which it was sold must ensure that the device is approved in the destination country. A list of approved countries appears in the SureCross DX80 Wireless
Product Manual, in the Agency Certifications section. The SureCross wireless products were certified for use in these countries using the standard antenna that ships with the product.
When using other antennas, verify you are not exceeding the transmit power levels allowed by local governing agencies. Consult with Banner Engineering if the destination country is
not on this list.