Banner K80 Pick-to-Light EZ-LIGHT - Manual (Page 8)

Retroreflective Tape
NOTE: For maximum adhesion of all tape products, surfaces must be clean.
Model Reflectivity Factor Maximum Temperature Size
BRT-THG-1-100 0.7 +60°C (+140°F) 25 mm (1 in) wide, 2.5 m (100 in) long
BRT-THG-2-100 0.7 +60°C (+140°F) 50 mm (2 in) wide, 2.5 m (100 in) long
BRT-THG-3-100 0.7 +60°C (+140°F) 75 mm (3 in) wide, 2.5 m (100 in) long
Mounting Brackets
All measurements in mm
SMB30A
• Right-angle bracket with
curved slot for versatile
orientation
• Clearance for M6 (¼ in)
hardware
• Mounting hole for 30 mm
sensor
• 12-ga. stainless steel
45
61
69
A
B
C
Hole center spacing: A to B=40
Hole size: A=ø 6.3, B= 27.1 x 6.3, C=ø 30.5
SMB30SC
• Swivel bracket with 30 mm
mounting hole for sensor
• Black reinforced thermo-
plastic polyester
• Stainless steel mounting
and swivel locking hard-
ware included
67
58
29
B
A
Hole center spacing: A=ø 50.8
Hole size: A=ø 7.0, B=ø 30.0
SMB30FA
• Swivel bracket with tilt and
pan movement for precise
adjustment
• Mounting hole for 30 mm
sensor
• 12-ga. 304 stainless steel
• Easy sensor mounting to
extrude rail T-slot
• Metric and inch size bolt
available
A
B 68.9 36.3
83.2
Bolt thread: SMB30FA, A= 3/8 - 16 x 2 in; SMB30FAM10, A=
M10 - 1.5 x 50
Hole size: B= ø 30.1
SMBAMS30RA
• Right-angle SMBAMS ser-
ies bracket
• 30 mm hole for mounting
sensors
• Articulation slots for 90+°
rotation
• 12-ga. (2.6 mm) cold-rol-
led steel
53
48
45
A
C
B
Hole center spacing: A=26.0, A to B=13.0
Hole size: A=26.8 x 7.0, B=ø 6.5, C=ø 31.0
SMB30MM
• 12-ga. stainless steel
bracket with curved
mounting slots for versatile
orientation
• Clearance for M6 (¼ in)
hardware
70
57
A
B
C
57
SMBAMS30P
• Flat SMBAMS series
bracket
• 30 mm hole for mounting
sensors
• Articulation slots for 90+°
rotation
45
93
A
C
B
EZ-LIGHT® K50 and K80 Series Pick-to-Light Sensors
8 www.bannerengineering.com - tel: 763-544-3164 P/N 126441_web
Rev.G