Banner K80 Pick-to-Light EZ-LIGHT - Manual (Page 5)

Specifications
Supply Voltage and Current
12 to 30V dc (10% max. ripple)
< 75 mA max current at 12V dc (exclusive of load)
< 40 mA max. current at 30V dc (exclusive of load)
Supply Protection Circuitry
Protected against transient voltages (fast-transient and
over-voltage) and reverse polarity
Output Configuration
1 current sinking (NPN) transistor or 1 current sourcing
(PNP) transistor, depending on model
Output Rating
Max load: 150 mA
ON-state saturation voltage: < 2V at 10 mA dc; <
2.5V at 150 mA dc
OFF-state leakage current: < 10 µA at 30V dc
Output Protection Circuitry
Protected against false pulse on power-up and continu-
ous overload or short-circuit of output
Output Response Time
3 milliseconds ON and OFF
Power-Up Output Delay Time
100 ms
Indicators
Entire translucent dome provides indicator light; either
Job or Pick Sensed indicator inhibits the other light, de-
pending on model
Job "Pick" Indicator: Green
Pick Sensed Indicator: Red or OFF, depending on
model
Job Light Enable Input
Input Impedance: 8000 ohms
Sinking - Input low < 1.0V
Sourcing - Input high > 7V
Construction
Base: Polycarbonate
Translucent Dome: Polycarbonate
Push Button: Thermoplastic
Lens: Polycarbonate or acrylic
Connections
Integral 4-pin Euro-style QD fitting, PVC-jacketed 2 m
(6.5 ft) or 9 m (30 ft) cable or 150 mm (5.9 in) PVC pig-
tail with 4-pin Euro-style QD fitting, depending on mod-
el
Accessory QD cables required for QD models, see
4-
pin Euro-Style Cordsets
QPMA-style PUR pigtail models are also available;
contact Factory for more information
Ambient Light Immunity
Up to 5,000 lux
EMI/RFI Immunity
Immune to EMI and RFI noise sources, per IEC
947-5-2
Environmental Rating
Fully encapsulated; IEC IP67
Integral QD models: DIN 40050 (IP69K) when using
IP679K-rated cables
Pigtail and cable models: IP69K when mounted with
conduit
Operating Conditions
Temperature: -40º to +50º C (-40º to +122º F)
Max. Relative Humidity: 90% at +50º C (non-con-
densing)
Certifications
K50 models:
All models except
push buttons
K80 models:
EZ-LIGHT® K50 and K80 Series Pick-to-Light Sensors
P/N 126441_web
Rev.G www.bannerengineering.com - tel: 763-544-3164 5