Metrohm 787 KF Titrino - Manual (Page 9)

1.2 Controls and parts
787 KF Titrino
5
6
RS232 interface
for the connection of printer, balance or a computer
7
Remote lines
(input/output)
for the connection of Sample Changers, robots etc.
8
Connection for the KF electrode
9
Connection for separate keypad
10
Analog output for the connection of a recorder
11
Connection for power cable
With power supplies where the voltage is subject to severe HF disturbances, the Ti-
trino should be operated via an additional power filter, e.g. Metrohm 615 model.
12
Mains switch
13
Earthing socket
14
Connection for Ti Stand or stirrer
703 Ti Stand or 728 Magnetic Stirrer
Supply voltage: 9 VDC (I ≤ 200 mA)
15
Display of the set mains voltage
Before switching on for the first time, check that the set mains voltage matches the
voltage of your power supply. If this is not the case, disconnect mains cable and
change voltage.
16
Rating plate
with fabrication, series and instrument number