Metrohm 847 Lab Link - Manual (Page 22)

2 Installation
• TCP/IP Setup
1. With [TCP/IP Setup] you can make network-relevant settings.
In order for you to be able to address the 847 USB Lab Link in your network
it must be given an IP address. The 847 USB Lab Link can then obtain it ei-
ther dynamically from a DHCP server (Step 2) or you can enter it directly in
the dialog shown above (Step 4ff.).
2. Dynamic IP address: Activate the checkbox Get IP address auto-
matically (DHCP) if the 847 USB Lab Link is to obtain the IP address
from a DHCP server. All the other parameters can then no longer be ed-
ited.
3. Confirm and exit the TCP/IP settings with [Back] .
Note
As soon as you exit the dialog with
[Back] and then restart your Touch
Control the, IP address, subnet mask and standard gateway assigned to
the 847 Lab Link by the DHCP server will be shown in this dialog.
18 847 USB Lab Link / Lab Link Server