Metrohm 816 IC Eluent Selector - Manual (Page 13)

2.1 Setting up the instrument
2 Installation
2.1 Setting up the instrument
2.1.1 Packaging
The 816 IC Eluent Selector and the separately packed accessories are
delivered in special packaging that provides excellent protection. It con-
tains impact-absorbing plastic foam. The instrument itself is packed in a
dustproof evacuated polyethylene bag. Please store this packaging in a
safe place; it is the only way in which the safe transport of the instru-
ment can be guaranteed.
2.1.2 Checks
Please check that the delivery is complete and undamaged
immediately on receipt (compare with delivery note and list of
accessories given in Section 4.2). If transport damage is evident please
refer to the information given in Section 4.5.1 Warranty.
2.1.3 Location
Place the instrument on a suitable vibration-free laboratory bench,
protected as much as possible from corrosive atmospheres and
contact with chemicals.
Choose a location where the temperature is usually between +5 °C and
+45 °C. The instrument should be protected against excessive
variations in temperature and direct sunlight.
2.2 Mains connection
Please observe the following rules when connecting the instrument to
the electricity supply. If the instrument is operated with an incorrectly
set mains voltage and/or an incorrect mains fuse then it represents a
fire hazard!
2.2.1 Setting the mains voltage
Before you switch on the 816 IC Eluent Selector for the first time please
check that the mains voltage set on the instrument (see Figure 2) corre-
sponds to your local mains voltage. If this is not the case then you must
alter the mains voltage as follows:
816 IC Eluent Selector/ 8.816.1003 Instructions for Use
7