Metrohm 816 IC Eluent Selector - Manual (Page 12)

1 Introduction
1.4 Safety information
Warning!
This instrument should only be used in accordance with the informa-
tion given in these installation instructions.
1.4.1 Electrical safety
Electrical safety when handling the 816 IC Eluent Selector is guaranteed
within the framework of the IEC 61010 Standard. The following point
must be observed:
• Mains connection
Mains connection and checking the fuses must be carried out in
accordance with the instructions given in Section 2.2.
• Opening the 816 IC Eluent Selector
When the 816 IC Eluent Selector is connected to the mains it must not
be opened, nor should any components be removed, as otherwise
you run the risk of contacting parts which are “live”. Always disconnect
the instrument from all voltage sources before opening it and make
sure that the mains cable has been removed from mains con-
nection 9 !
• Protection against electrostatic charges
Electronic components are sensitive to electrostatic charges and can
be destroyed by a discharge. Before you touch any component inside
the 816 IC Eluent Selector you should ground yourself and your tool
by touching a grounded object (e.g. instrument housing or radiator) to
eliminate any existing electrostatic charges.
1.4.2 General safety rules
• Handling solutions
Check all inlets and outlets for leaks at regular intervals. Observe the
appropriate regulations for the handling and disposal of flammable
and/or toxic solutions.
816 IC Eluent Selector/ 8.816.1003 Instructions for Use
6