Metrohm 827 pH lab - Manual (Page 44)

7.1 Reports
36
826/827 pH meter, Instructions for Use
7.1.1 Arrangement of a report
The first lines of a report provide a general description. This report
header is configured under configuration/report (see Section 5.1):
Report Id: 'mp
Device Id: 827 pH lab 01106 5.827.0010
Date, Time: print date 2005-01-27 14:21:52
...
If you have entered a device identification (dev.label) under configu-
ration/report then this will appear in the report header as an addi-
tional line between the device Id and the line date/time. A further defin-
able identification for the report header (id) will appear subsequently to
the line date/time (measuring point and calibration report only).
Each report is concluded with a finishing line. For an automatically
triggered original report (measuring point or calibration report) this is
in the form of a double line:
==============
Each report triggered manually via the menu << report >> is con-
cluded with a single line:
--------------
7.1.2 Report identification
The report identification, known here as Report Id, is an abbreviation
describing the type of report.
The following report Ids exist for the 826 pH mobile and 827 pH lab:
Report Id
Report name
'cr pH calibration report
'co configuration
'pa parameter
'mv measured values stored
'mp measuring points
'md measuring values to database (PC/LIMS)
'di diagnosis