Metrohm 827 pH lab - Manual (Page 43)

7 Various functions
826/827 pH meter, Instructions for Use
35
7 Various functions
This section describes various functions of the pH meter which cannot
be assigned to individual modes.
7.1 Reports
A pH meter report is produced by transmitting data to a printer or com-
puter via the infrared interface. In this way you can document e. g.
measuring results, calibration data or the configuration of the instru-
ment in written form.
A requirement for a properly functioning report output is the activation
of the infrared interface (see Section 5.4).
The following reports can be printed automatically:
•
Calibration report: The report of the current calibration can be
printed additionally to each printed measuring point. Therefor acti-
vate the parameter report under param/cal.settings.
• System test report: The result of the system test after switching on
the pH meter is printed out automatically if the parameter sys.test
rep. under configuration/report is activated.
Apart from the measuring point report, all reports can be triggered ma-
nually at a later date via the menu << report >>. The required report
can be selected with the arrow keys <> or <> after confirming
with :
cal
Calibration report
config Instrument configuration report
param Parameter report of the pH measurement
mval Output of all stored measured values
pc/lims Output of all stored measured values in machine
readable form for storage with a PC
all Output of all existing reports
The reports cal and param are only available in the pH mode.
Attention!
The report output can be terminated at any time with . For
this reason you should wait for the report output to be finished before
operating the pH meter again. In this way you avoid the accidental
cancellation of a report output.
The following pages show the arrangement of reports together with the
different types of reports.