Metrohm 760 Sample Changer - Manual (Page 22)

3.4 Configuration Procedure
760 Sample Changer, Introduction
19
HOLD
red blinks
green 5 ∗
The key switches on the stirrer(s). If the
key is kept pressed down the speed increases continuously.
If the key is pressed again the stirrer speed is re-
duced in a similar manner. In this way the stirrer speed can
be set accurately.
START
blinks
accepts the setting. The configuration procedure
is now complete. It can be restarted by pressing in
order to select the method.
STOP
RESET
lights up
The configuration procedure is terminated with .
When the green LED is illuminated the sample changer is in
the basic condition and is ready to process a series of sam-
ples.
The individual steps of the configuration procedure:
1
∗ Method selection
2
∗ Setting the working position
3
∗ Setting the rinsing position
4
∗ Setting the shift position
5
∗ Setting the stirrer speed