Metrohm 835 Titrando - Manual (Page 28)

2.5 Device connection at the USB
22
Titrando Installation Instructions
2.5.2 Connecting a balance
If you are operating the Titrando with the PC Control/tiamo software
then connect the balance directly to the serial interface (COM) of the
computer. This is normally 9-pin and marked with the symbol IOIOI. If
you are operating the Titrando with the Touch Control then you need
the 6.2148.020 USB-RS232 box to connect a balance.
The following table gives an overview of the balances that can be used
together with the Titrando system and which cables you will need to
connect the balance to the RS232 interface:
Balance Cables
AND
ER-60, 120, 180, 182
FR-200, 300
FX 200, 300, 320
with RS232 interface (OP-03)
6.2125.020 + 6.2125.010
Mettler AB, AG, PR (LC-RS9) Supplied with balance
Mettler AM, PM, PE with interface
option 016
or
Mettler AJ, PJ with interface op-
tion 018
6.2146.020 + 6.2125.010
additionally from Mettler:
ME 47473 Adapter and either
ME 42500 Hand switch or
ME 46278 Foot switch
Mettler AT 6.2146.020 + 6.2125.010
additionally from Mettler:
ME 42500 Hand switch or
ME 46278 Foot switch
Mettler AX, MX, UMX, PG, AB-S,
PB-S
6.2134.120
Mettler AE with interface option
011 or 012
6.2125.020 + 6.2125.010
additionally from Mettler:
ME 42500 Hand switch or
ME 46278 Foot switch
Ohaus
Voyager, Explorer, Analytical Plus
Cable AS017-09 from Ohaus
Precisa
balances with RS232C interface
6.2125.080 + 6.2125.010
Sartorius MP8, MC1 6.2134.060
Shimadzu BX, BW 6.2125.080 + 6.2125.010