beautypg.com

Ideo, Onnection, 2 video connection – DJI H3-3D User Manua User Manual

Page 14: Tips

background image

©2014 DJI Innovations. All Rights Reserved.

14

2.2 Video Connection.

Wireless video transmission transfers video signal from the on-board camera to the GCU via the gimbal video

signal cable. Follow the figure below to complete the connection.

Wireless Video
Transmission Module

Air System

Video Signal Port

GND(Black:

  )

Gimbal Video Signal Cable

Video Signal

GND

Leave as-is

Video Signal(Yellow:AV)

Power

External power

1.

Solder the Video Signal/GND cables to wireless video transmission module (air system).

2.

Plug the gimbal video signal cable jack into the GCU video signal port.

Notes

(1)

Ensure to connect the wireless video transmission unit to the GCU before powering on the aircraft.

(2)

It is recommended to use standard gimbal video signal cable. Make sure you solder the gimbal video

signal cable to the wireless video transmission module firmly. Insulated all the cables to prevent short

circuiting.

Leave as-is

Video Signal Cable(AV)

GND Cable

(3)

GCU does not provide power to the wireless transmission module. Refer to the wireless video

transmission module manual for details on the power supply connection.

Tips:

(1)

The below diagram shows the how video signal flows from the on-board camera to the gimbal.

(2)

Should error occurs, examine each checkpoints on the below diagram to locate the source of the

problem.

Camera

Video Port

Gimbal

Camera Interface

GCU

G8

AV signal

Wireless video
transmission module

Air System

8-Pins cable

Gimbal Video
Signal Cable

Wireless video
transmission module

Ground System

Wireless signal

Monitor

AV input

5.8G/2.4G/1.2G

Supplied by user

AV signal

AV signal

AV signal