Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 64)

63
Intr
odu
ctio
n
Par
ts D
escription
PM
T In
sta
llati
on
Op
era
ting
Ins
tru
ctio
ns
appeNDIx:
The appendix contains important information for the PMT and is split into five sections.
• seCTION 1: pyROMeTeR CaLIBRaTION pROCeDURe
• seCTION 2: TRaNsMIssION ReLeaRN pROCeDURes: FORD aND GM
• seCTION 3: CUsTOM a-pILLaR paRT NUMBeR INFORMaTION
• seCTION 4: TROUBLesHOOTING/eRROR CODes
• seCTION 5: FORMaTTING sD CaRD
• seCTION 6: WaRRaNTy/DIsCLaIMeR
seCTION 1: PYROMETER CALIBRATION PROCEDURE
BEFORE THIS STEP CAN BE COMPLETED, COMPLETELY INSTALL THE PMT AND ALL OF ITS COMPONENTS.
1. Vehicle must be set to Stock HP/TQ levels-meaning no HP/TQ modifications of any kind (downloader or plug-in
modules).
2. Engine must be put under full load for as long as possible on the hottest day possible. It is suggested to drive up a
hill or pull a trailer.
3. During a heavy load pull, record the highest reading.
4. Take that reading and add 150° to the high number and that will be your new defuel number that you do not
want to exceed.
APPENDIX
Inte
rne
t U
pda
tes
App
end
ix