Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 24)

23
PMT INSTALLATION
Intr
odu
ctio
n
Par
ts D
escription
Op
era
ting
Ins
tru
ctio
ns
Inte
rne
t U
pda
tes
App
end
ix
INsTaLLING THe pCH BOaRD
The pyrometer that was installed will now have to be connected to the PCH Board, but first the PCH
Board needs to be mounted in a secure location that both of the pyrometer ends can reach.
1. Gather all of the parts of the PCH Board assembly:
• Pyrometer Connection Head with PCH Cable
• Self-tapping Sheet Metal Screws
• Velcro
• Jumper
• Zip Ties
2. The PCH Board needs to be mounted in a location
that is secure (away from extreme heat and mov-
ing parts), and in a location in which the end of
the Pyrometer Cable can easily reach.
3. Use the sheet metal screws or Velcro, or both to
securely attach the PCH Board to a safe location
within the engine bay.
4. To connect the end of the Pyrometer Cable to the PCH Board, first remove the screw and nut on
the end of the pyrometer leads, then remove the screws from the Pyro 1 heads on the PCH Board.
Use those screws to secure the Pyrometer Cable leads to the PCH Pyro 1 heads, see the PCH As-
sembly Diagram (pg. 19) for a visual reference when connecting the pyrometer leads to the PCH
Board.
Notice: Do not remove the jumper from the pyrometer 2 location unless you are
installing a second pyrometer.
If connecting two pyrometers keep track of which location, pyro 1 or 2, each
pyrometer was attached to on the pCH Board
5. Once the PCH Board is secure and the pyrometer(s) is/are connected to the PCH Board, use zip ties to
secure the pyrometer cables away from extreme heat and moving parts.
6. Run the end of the PCH Cable through the fire wall. It will need to be connected to the OBDII Adapter
Plug. Use zip ties to secure all remaining cable left inside the engine bay.
PM
T In
sta
llati
on