Bully Dog 40300 PMT advanced vehicle downloader, controller, monitor and gauge - Manual (Page 13)

2
PMT INSTALLATION
Intr
odu
ctio
n
Par
ts D
escription
Op
era
ting
Ins
tru
ctio
ns
Inte
rne
t U
pda
tes
App
end
ix
2. With all assembly pieces gathered, refer to the Pillar Pod Mount Assembly Diagram for a visual
reference on how the assembly fits together. Steps 3 through 6 explain how to assemble the pieces,
the A Pillar Mount Diagram shows what the assembled mounting style looks like.
Note that installation instructions for each vehicle specific Custom A-Pillar Pod are included
with the Custom A-Pillar Pod, and are not described here.
3. Insert the ball that is on the back of the cradle into the lower hole on the front of the Front Mount-
ing Plate and then shift the ball into the center of the Front Mounting Plate. Make sure that the
extruded part of the Front Mounting Plate is facing the cradle when inserting the ball.
4. Run the Cradle Cable and Power Wire through the lower hole on the front of the Front Mounting
Plate and then through the hole on the front side of the Custom A-Pillar Pod. Pull all of the slack in
the Cradle Cable and Power Wire through the Front Mounting Plate and the Custom A-Pillar Pod.
5. With the Cradle still attached, put the Front Mounting Plate up to the hole on the Custom A-Pillar
Pod, then place the Back Mounting Plate up to the backside of the of the hole on the Custom A-Pillar
Pod. Make sure that the slot on the Back Mounting Plate is pointing downward like in the Custom
A-Pillar Pod Mount Assembly Diagram so the Cradle Cable and Power Wire can get through the
mount and down to the OBDII Adapter Plug and vehicle fuse box.
6. Use the four mounting screws to secure the connection of all pieces in the assembly. Tighten the
screws all the way down. See the Custom A-Pillar Pod mount diagram, finished assembly should
look identical.
7. To install the A-Pillar Pod Mount assembly on a vehicle refer to the instructions included with the
Custom A-Pillar Pod.
8. Run the end of the Cradle Cable and Power Wire down through the driver’s side of the vehicle
dash and pull all of the extra slack in the cable down also. The Cradle Cable plug will need to be
connected to the OBDII Adapter Plug and the Power Wire will need to be hooked to a fuse in the
vehicle fuse box.
PM
T In
sta
llati
on