Boomba Racing SRT-4 Dodge Engine Mounts Bolts Set - Manual (Page 2)

21
Install the splashguard.
22
Install and secure the right (passenger
side) wheel.
19
Line up top mount with adaptor block.
Install the bolt but don't tighten it yet. Line
up the top mount with the slot on the body
side.
20
Insert the body side bolt. Tighten all top
mount bolts.
13
When using Boomba bolt set we need to
recycle one of the stock bolts.
14
Line up bottom mount with the mounting
holes and tighten all bolts.
15
Install tie bar.
16
After tightening the bolt the bottom mount
engine side bushing should look like on
the following picture. It should remain in
the center with no excessive bends in any
direction.
17
When looking from the top, the bushing
should be square to the mount bracket.
We allow maximum +/- 1-degree
variation.
18
Install the top adapter block but don't
tighten bolts yet.