Boomba Racing ST/2.0 Focus Fusion Pulley Alignment Tool Kit - Manual

FORD FOCUS ST
PULLEYS
2 There are no physical features
(dowel pins or key ways) registering
the pulley and timing to the crank
shaft. Follow manual to avoid
damage to the engine. 3 Remove the right front wheel. 4 Remove the right wheel well liner.
5 Remove the front lip and the under tray. 6 Remove the middle air supply duct. 7 Remove the air supply elbow. 8 Remove valve cover vent hose.
9 Remove the bolts securing the turbo
supply air duct to the valve cover.
10
Loosen the turbo air inlet hose clamp.
Remove the turbo supply air duct.
11
Disconnect the wire harness plugs on the
top of the valve cover. Disconnect BOV
solenoid hoses.
MATERIALS REQUIRED
Black oil resistant gasket
maker
Blue Loctite
TOOLS REQUIRED
M7, M8, M10, M13, M19,
M21, M28 sockets
M10, M12, M15 box
wrench
M24 open end wrench
M4 allen wrench T27, T30 Torx wrench
Flat screw driver
Pliers
Impact wrench
Torque wrench with angular
read out
12
Disconnect the main vacuum line from the
vacuum pump. Remove the BOV solenoid
valve.
1 When lifting the car
always use stands to
secure the car.