Bird Technologies 8640B Series - Manual (Page 7)

Bird 8640 and 8640B Series Moduload RF Load Resistor
vi
About This Manual
This manual covers the Bird 8645B and 8646B Moduload RF Load
Resistors.
This instruction book is arranged so that essential information on safety
is in the front of the book. Reading the Safety Precautions before
operating the equipment is strongly advised. The remainder of this
instruction book is divided into Chapters and Sections.
Operation
First time operators should read Chapter 1 - Introduction, and Chapter 3
- Installation, to get an overview of equipment capabilities and how to
install it. An experienced operator can refer to Chapter 4 - Operating
Instructions. All instructions necessary to operate the equipment are
contained in this chapter.
Maintenance
All personnel should be familiar with preventative maintenance found in
Chapter 5 - Maintenance. If a failure should occur, the troubleshooting
section will aid in isolating and repairing the failure. Parts lists and
repair instructions are also in this chapter.
Changes To The Manual
We have made every effort to ensure this manual is accurate at the time
of publication. If you should discover any errors or if you have suggestions
for improving this manual, please send your comment to our factory. This
manual may be periodically updated. When inquiring about updates to
this manual, refer to the part number and revision level on the title page.
Naming Conventions
The following terms will be used throughout this manual to refer to
certain components of the Moduload:
Moduload:
The entire unit.
Load:
The component which connects to the RF line. It is inside the HEAT
EXCHANGER, connected by two hoses. It contains the RESISTOR.
Heat Exchanger:
The parts of the Moduload left when the LOAD is
removed. It contains the pump, fans, coolant reservoir, and controls.