Bendix Commercial Vehicle Systems C-300N HYDRAULIC POWER STEERING1/99 - Manual (Page 12)

12
FIGURE 17 - SIDE COVER REMOVAL/INSTALLATION
FIGURE 15 - SEPARATING VALVE BODY & HOUSING
FIGURE 16 - REMOVING/INSTALLING PITMAN ARM & DUST
BOOT
2. Scribe a line or otherwise mark the relationship of the
valve body to the housing. Using a 19mm wrench remove
the four bolts (40) that secure the valve body (7) to the
housing (22). Figure 14
3. Separate the valve body(7) from the housing (22) by
rotating the output shaft (25) using the pitman arm. It
may be necessary to hold or rotate the input shaft (3)
during this operation. Continue to separate the valve
body from the housing until both O-rings (12) on the
valve body can be seen. Figure 15.
4. Scribe a line or otherwise mark the relationship of the
pitman arm to the output shaft (25), then remove the
pitman arm, then the dust boot (39). Figure 16
CAUTION: Do not use heat or pound on the pitman arm
or output shaft as damage can result. These components
must be replaced rather than repaired if they are
damaged. Remove any accumulated dirt, grease, grime,
and corrosion from the exposed portion of the output
shaft to facilitate removal through its seals.