Bendix Commercial Vehicle Systems COMPACT 500 9/87 - Manual (Page 18)

18
FIGURE 36 FIGURE 35
Without removing tool 297676, insert the nut(33) into
the valve body(16), screw and tighten it to a torque of
330 ft. lbs. with a spanner wrench. (See Figure 35)
NOTE: Tool 297676 for the teflon glide rings will come
out as the nut is screwed into the valve body. Lock
the nut in the valve body by staking the edge of the
valve nut into the valve body.
PISTON ASSEMBLY
5. Refer to Figure 37. Install stop washer (56), limiting valve
stem(54), limiting body(53), in the appropriate end of
the piston(48). Apply a small amount of LOCTITE 222
on the threads of the limiting body nut(52) and install
the nut in the piston. Torque the nut to 17 foot pounds
using the 6mm hollow hex wrench (Tool 297660) and a 6
mm socket.
From the opposite end of the piston install one of the two
ball valves (29), the spring (57), ball valve (29), stop washer
(56), limiting valve stem (55), limiting body (53). Apply a
small amount of locktite 222 on the threads of the limiting
body nut (52) and install the nut in the piston. Torque the nut
17 foot pounds using the 6mm hollow hex wrench and a
6mm socket.
34
297676
33
16
49
29
50
51
46
47
FIGURE 37
56
29 53 29
48
57 56 55 54 52
53
52
NOTE: The limiting valve stems (54&55) must be
installed in the same end of the piston as they were
removed. Reference Disassembly, Step 10. When
installing new stems (54&55), the shorter stem must
be installed facing the valve body housing side.
Install the ball screw by inserting it into the piston (48). (See
Figure 36)