Autocue WinCue Pro News - Manual (Page 24)

WINCUEPRO FOR AVSTAR USER GUIDE TECHNICAL SUPPORT
PREV Jump the prompt back to the previous story.
ITEM
RESET
Reset the prompt back to the start of the current story.
ITEM
Middle row of buttons (left to right):
NEXT
jumps to the next marker in the item that is being prompted
MARKER
PREV
jumps to the previous marker in the item that is being prompted
MARKER
RESET
Reset the prompt back to the start of the current runorder.
R.O. Must be pressed after receiving the initial AvStar download.
BLANK
Blanks/Un-blanks the prompt output. (Useful if you feel an interviewer may be put
SCREEN off by prompt on the camera)
Bottom row of buttons (left to right):
CAPTION
No assigned function for the AvStar Interface.
ON/OFF
2nd from left,
Known as the 'CUE STORY' button, it will move the prompt back to the very end of
bottom row. the previous story. This is useful to ensure that you are not pre-empting the gallery
as to which is the next story to prompt. Yet you are still able to display enough of the
next story for the presenter to start reading it. It is only worth using this button if
AvStar controls the runorder.
CLEAR
No assigned function for the AvStar Interface.
DECODER
STOP
Stop/Re-start the prompt scrolling.
1.4.2 Using the Foot Control to Prompt
The scroll speed is controlled by increasing and decreasing the pressure applied to the foot pedal
(much like a car accelerator pedal). The red button on the foot control changes the scroll direction in
the same way as the Multibutton controllers FWD REV button.
If the Foot Control is attached to the back of a Multibutton Hand Control then the Foot Control can be
used in combination with the Multibutton Controls buttons.