Autocue WINCUE - Manual (Page 63)

WINCUE USER GUIDE CHAPTER 9 – WINCUE RUNDOWNS
63     AUTOCUE LTD. 2002
9.3.6 Editing the fields of an item in the rundown
You can change data in fields in the rundown by clicking once to select the field and clicking again to
highlight the field, which can then be edited. Or you can right-click on the field and select Edit Field. You
can then overtype the contents of the field or move the cursor into position to edit. Or press F2 anywhere
on the item line to edit the first field. Press ENTER to save the change or Press the TAB button which
takes you to the next field and saves the change. SHIFT+TAB takes you back a field. Press ESCAPE to
finish the process. To clear a field right-click on it and select Clear Field.
When a field is highlighted, you are in Edit mode and can move up and down the rundown in that
field using the cursor keys or press the TAB key to jump to the next field of the item. You will remain
in edit mode until you finish the process by pressing ENTER to save any changes or by pressing
ESCAPE.
9.3.7 Toggle Hold State
You may wish to put an item in the rundown on hold if it is not ready or you don't want it to be part of the
transmission, so it is not prompted and included in any timing calculations. To put an item on hold, right-
click on that item in the rundown and choose Toggle Hold State from the pop-up menu. That item will then
be in blue. To take off hold repeat the process.
9.3.8 Move to Air Next
The Move To Air Next command allows you to begin prompting from anywhere within the rundown. To do
this right-click on the item you want to prompt from and select Move to Air Next from the popup menu.
OR you can click on the Prompt Here button adjacent to each item in the rundown:
The item selected changes to yellow and you can start scrolling from there.
9.4 View Settings
There are various view settings available in the rundown by opening the View menu and selecting Settings…