Warning – Autocue WINCUE User Manual
Page 23
WINCUE USER GUIDE
CHAPTER 4 – CONFIGURING WINCUE
23
AUTOCUE LTD. 2002
The simple serial scroll control sends serial data in the range 0 to 120 to tell WinCue how fast to prompt the text; 0
is stop and 120 is the fastest scroll rate. This scroll rate is determined by the position of the scroll control knob. If the
Stop Point is set to 60, scroll rates of less than 60 will prompt the text backwards, scroll rates greater that over 60
will prompt the text forward, and a scroll rate of exactly 60 will stop the text from scrolling.
The Stop Zone is a range between 0 and 40 over which the prompted text does not scroll. If the Stop Point is set to
60 and the Stop Zone is set to 5, scroll rates between 55 and 65 will mean the prompted text is not scrolled.
Warning!
Administrators should not attempt to modify either the Configure IMT End Stop Scroll Table or
Configure IMT Centre Stop Scroll Table. If modifications are required to either scroll table you
should contact your vendor.
Click OK when you are happy with your settings. This will take you back to the Configure Scroll Controls window.
Now you need to configure the prompt engine.
4.3
Configuring the Prompt Engine
Click on Prompt engine and then Settings, which will open the Layout window.