Rockwell Automation 1769-L16ER-BB1B_L18ER-BB1B_L18ERM-BB1B CompactLogix 5370 L1 Controllers System Quick Start - Manual (Page 38)

38 Rockwell Automation Publication IASIMP-QS024B-EN-P - December 2012
Chapter 2 Prepare the Computer and Load Controller Firmware
6. Verify that the driver’s Status is
Running and click Close.
Set the IP Address for the Computer
Your computer requires an Internet Protocol (IP) address to operate on an EtherNet/IP
network. The IP address uniquely identifies the controller and is in the form
xxx.xxx.xxx.xxx
where each xxx is a number from 000…254 with some exceptions for reserved values.
A computer’s IP address can be set automatically or manually. The manual option is typically
used with isolated networks. This section describes how to set the IP address manually.
For more information on setting an IP address for your CompactLogix 5370 L1 controller, see
the CompactLogix 5370 Controllers User Manual, publication
1769-UM021 .
1. On your desktop, right-click
Network and choose Properties.