Rockwell Automation FactoryTalk ViewPoint Quick Start Guide - Manual (Page 34)

F ACTORY T ALK V IEW P OINT Q UICK S TART
30
Set command writes a value to a tag.
The syntax for the Set command is [&] Set [/V]
 [&] forces the command to be evaluated asynchronously, which can dramatically
improve the performance of tag writes.
 [/V] performs read-back verify on the write.
 [/V] provides an extra level of security by performing a read immediately after
the write to verify that the value was actually altered in the programmable
controller or OPC server.
 This option is useful if the communications network is in poor condition, or
susceptible to noise interference.
 If the verification fails, the error message is sent to the Factory Diagnostics
system
 is a relative or absolute reference to the tag whose value will be set.
 is a value and tag to set.
Toggle command reads the tag's value and writes back a 0 or 1. If the value is 0,
Toggle changes it to 1; if the value is 1, Toggle changes it to 0.
The syntax for the Toggle command is Toggle [/V]
 [/V] performs a read immediately after the write to verify that the value was
altered in the programmable controller or server.
 This parameter is useful if the network is in poor condition or susceptible to
noise interference.
 If the verification fails, the error message is sent to the Factory Diagnostics
system.
 is a relative or absolute reference to an analog or digital HMI tag.
FTViewPointQS.book Page 30 Thursday, July 17, 2014 8:55 AM