Rockwell Automation Emonitor with a Gupta Multi-User Database - Manual (Page 30)

I NSTALLING E MONITOR S OFTWARE WITH A G UPTA SQLB ASE M ULTI -U SER D ATABASE
26
• •
•
•
•
If you are upgrading from Emonitor version 3.40 to version 3.50, you do not need to
restructure your database before you can connect to the database from a client computer.
This allows you to continue to use Emonitor during the process of upgrading, and then
restructure the database after all the client computers are upgraded. Note that some new
features in Emonitor 3.50 may not be available until you restructure the database.
If you are upgrading from Emonitor 3.30 (prior to the Emonitor version 3.30 Service
Release) or earlier, you must run the restructure program before any upgraded client can
connect to the database.
1. Start your Emonitor software from the Start menu on any client computer (Start >
Programs > Rockwell Software > Emonitor > Emonitor). Click Yes to update your
database.
After you enter the Admin user name and password, the restructure program
automatically starts. The default Admin username and password are “admin” and
“password”.
2. Click Restructure to begin the update process.
3. Make sure you have backed up your database, then click OK to continue.
You must restructure the database after updating before you can use Emonitor Web.