4 - using the e3 module, Introduction, Chapter 4 – Rockwell Automation MMCL Using the Mining, Mineral, and Cement Library (MMCL) in RSLogix 5000 Appli User Manual

Page 31: Using the e3 module

Text mode
Original mode

Publication RA-UM002B-EN-P - November 2010

Chapter

Using the E3 Module

Introduction

The E3p_AOI module is an interface block between Network (scanner) and
Motor block. Templates using the E3 module operate the same as regular
Motor

module but with the add-on information from the E3 module:

warning status, trip status, therm., utilized and average current. The E3p_AOI
does not have a specific HMI Template. Each Motor Device with E3plus
Overload Relay will call a specific HMI Template such as
03_MotorN_E3_small or 03_MotorN_E3_largel.

There are no parameters to configure inside the E3 module structure.