Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 80)

Communication Setup (Synapse Cable) 5–19
Publication 2755-6.4
Setting Scanner Emulation Synapse Cable Options
This section defines the communication options available when the
scanner is connected to this Scanner Emulation Synapse cable:
•
Catalog No. 2755-HFC-SA1-01
Default Settings
Scan the Set Scanner Emulation Cable Defaults bar code to set the
Synapse cable to default settings. Refer to the table below for the
default settings.
Parameter Default Setting
Refer to
Description
on Page:
Programming
Guide➀
Page Reference
Emulation Standard 5–20 6-2
Leading Margin 80 Millisecond 5–20 6-3
Decode LED Enabled 5–20 6-3
Emulation Timeout 3 Seconds 5–21 6-4
Polarity Margin Low / Bar High 5–21 6-5
Unknown Characters
Send Bar Codes with
Unknown Characters
5–21 6-5
Convert All to Code 39 Disabled 5–22 6-6
Code 39 to Code 39
Full ASCII
Disabled 5–22 6-6
Parameter Set Parameter Set 1 5–23 6-7
➀ Programming Guide for 2-D Bar Code Scanners (Publication 2755-6.7)