Rockwell Automation 2080-REMLCD Micro800 Remote LCD Installation Instructions - Manual (Page 5)

Micro800 Remote LCD 5
Rockwell Automation Publication 2080-IN010A-EN-P – December 2013
• Make sure all connectors are securely tightened to properly seal the
connections against leaks and maintain IP enclosure type requirements.
• The USB port is intended for temporary local programming purposes only and
not intended for permanent connection.
• The USB cable is not to exceed 3.0 m (9.84 ft) and must not contain hubs.
• The RS232 and Power cables are not to exceed 3.0 m (9.84 ft).
• Do not place the module in direct sunlight. Prolonged exposure to sunlight may
degrade the LCD.
• The USB cap must be in place to maintain IP65 rating.
• If you connect or disconnect the RS232 cable with power applied to this module
or the serial device on the other end of the cable, an electrical arc can occur.
This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
• If you connect or disconnect the communications cable with power applied to
this module or any device on the network, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
• When used in a Class I, Division 2, hazardous location, this equipment must be
mounted in a suitable enclosure with proper wiring method that complies with
the governing electrical codes.
• The USB port is intended for temporary local programming purposes only and
not intended for permanent connection. If you connect or disconnect the USB
cable with power applied to this module or any device on the USB network, an
electrical arc can occur. This could cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
• Do not connect directly to line voltage. Line voltage must be supplied by a
suitable, approved isolating transformer or power supply having short circuit
capacity not exceeding 100V A maximum or equivalent.
• Do not use the USB port in hazardous locations.