Rockwell Automation 2080-REMLCD Micro800 Remote LCD Installation Instructions - Manual (Page 13)

Micro800 Remote LCD 13
Rockwell Automation Publication 2080-IN010A-EN-P – December 2013
Mount the Module on a DIN Rail
The module can be mounted using the following DIN rails: 35 x 7.5 mm and 35 x 15 mm (EN
50 022 - 35 x 7.5 and EN 50 022 - 35 x 15).
The module can be mounted on the same DIN rail as the controller.
Before mounting the module on a DIN rail, use a flat-blade screwdriver in the DIN rail latch and
pry it downwards until it is in the unlatched position.
1. Hook the top of the DIN rail mounting area of the Micro800 Remote LCD module
onto the DIN rail, and then press the bottom until the module snaps onto the DIN rail.
2. Push the DIN rail latch back into the latched position.
To remove your module from the DIN rail, make sure you pry the DIN rail latch downwards
until it is in the unlatched position and slowly disengage the module from the bottom of the rail.
IMPORTANT
Do not push on the LCD display when pushing the terminal into the
panel or you may damage the display.
ATTENTION: Follow the instructions to provide a proper seal and to
prevent potential damage to the device. Allen-Bradley assumes no
responsibility for water or chemical damage to the terminal or other
equipment within the enclosure because of improper installation.
OK
ESC
F4 F5
F1 F2
F3
F6
MENU
USB
46253
97 (3.82)
130 (5.12) 35.5 (1.40)
Measurements are in millimeters (inches)