Rockwell Automation 2100 CENTERLINE MCC Retrofitting Units with Horizontal Operating Handles - Manual (Page 6)

Publication 2100-IN065A-EN-P—September 2006 6 Copyright © 2006 Rockwell Automation, Inc. Printed in the U.S.A.
Supersedes Publication 2400-5.4 - September 1990
8. Feed the ground wire out the right side of the unit and through the
wireway cutout in the right hand unit support. Attach the unsecured end
of the wire to the front flange of the sidesheet with a 10-32
thread-forming screw. Use the small hole below the notch that is level
with the unit support pan (Figure 4). Torque the screw to 32 lb-in
(3.6 N-m).
9. Complete the unit insertion procedure.
NOTE: If large cables are being wired to unit devices, it may be necessary to
enlarge the wireway cutout in the right hand unit support for easier access and
increased bending room.
10. Mount the door to the structure and insert the hinge pins.