Rockwell Automation 2100 CENTERLINE MCC Retrofitting Units with Horizontal Operating Handles - Manual (Page 4)

Publication 2100-IN065A-EN-P—September 2006
4 CENTERLINE® 2100 Motor Control Centers Retrofitting Units with Horizontal Operating Handles Into Series “E” Through “J” Sections
Figure 3 Door hinge assembly
5. Attach one end of the ground wire to the inside of the unit backplate
with a 10-32 thread-forming screw. Use the hole at the top, to the left of
the stab molding (Figure 4, page 5).
NOTE: This hole may already be used for the ground wire of a transformer.
If so, remove the screw which holds the transformer wire, then secure both
wires with the 10-32 thread-forming screw. Torque the screw to 32 lb-in
(3.6 N-m).
.44 (7/16)
.44 (7/16)
2.88 (2-7/8)
Door
Add .219 (7/32) Holes
(Required on Section
Series Letter “E” Thru “G”) Cabinet
Sideplate
Existing Holes
Door Hinge Pins
1/4-20 x 1/2 thread
forming screw
Hinges