Rockwell Automation 2100 CENTERLINE MCC Retrofitting Units with Horizontal Operating Handles - Manual

1 Publication 2100-IN065A-EN-P—September 2006
Instructions
CENTERLINE ® 2100 Motor Control Centers
Retrofitting Units with Horizontal Operating
Handles Into Series “E” Through “J” Sections
Application This publication details the retrofitting procedure for units with horizontal
operating handles that plug into CENTERLINE
® 2100 sections with series
letters “E” through “J.”
Recommended Tools Screwdriver
Wrenches or sockets in the following sizes: 5/16” and 3/8”
Torque wrench
Preparation 1. Verify parts (shown in Figures 1, 3, 4 on pages 2, 4, 5).
Parts list:
a. Latch (1)
b. Hinges (2)
c. 1/4-20 x 1/2 thread-forming screws (2)
d. Door hinge pins (2)
e. Ground wire (1)
f. 10-32 x 3/8 thread-forming screws (2)
2. Check section series letter. These instructions only apply for
sections with series letters "E" through "J."